Owner's manual

UAD Powered Plug-Ins Manual - 50 - Chapter 3: API 500 Series EQ Collection
API 560 Controls
Note: Like the original 560 hardware, the signal is boosted by approxi-
mately 1 – 1.5 dB even when all gain sliders are set to 0 dB.
Gain Sliders Each of the 10 sliders controls the gain for one fre-
quency band. Each band can be adjusted to boost or cut
the frequency by up to ±12 dB. The available band fre-
quencies are listed in T
able 8 below.
Tip: To return a slider to the 0 dB position, click the
slider’s frequency text label. To reset all sliders to 0 dB,
click the “0” text label above the sliders.
Output This control provides -24 dB to +12 dB of clean uncolored gain
at the output of the plug-in.
Tip: Click the “0” text label to return Output to the 0 dB position.
EQ In The EQ In switch enables the filter sliders. The EQ bands are
active when the switch is engaged and the associated “IN”
LED is illuminated.
When disengaged, the EQ bands are bypassed but other hardware circuitry
is still modeled.
Power The plug-in is active when the POWER switch is engaged and its
associated LED is illuminated. When this switch is off, all plug-in
processing is disabled.
Table 8. API 560 Frequencies
16 kHz
8 kHz
4 kHz
2 kHz
1 kHz
500 Hz
250 Hz
125 Hz
63 Hz
31 Hz