Manual

UAD Powered Plug-Ins Manual - 30 - Chapter 2: Ampex ATR-102
Thru
Thru is a processor bypass control. When Thru is enabled, all controls are in-
active, emulation processing is disabled, and DSP usage is reduced.
Thru behavior is similar to that of the OFF position in the POWER control
(page 26), except that the Meters are still active in Thru mode. In this state, the
Meters indicate signal levels at the input of the plug-in prior to processing.
Note: DSP usage is reduced only when DSP LoadLock is disabled. If DSP
LoadLock is enabled (the default setting), activating Thru will not reduce DSP
usage.
Tape Reels
Animation
When the secondary controls panel is closed
(Figure 1 on page 19), by default the graphi-
cal tape reels “spin” if the DAW transport is
running. The tape reels animation can be dis-
abled by clicking the capstan graphic.
Re-clicking the capstan will re-start the animation.
The “spin state” is saved until it is changed again.
Note: Spinning reels automation is not supported in all hosts. In Sonar, the
plug-in must be configured as a “tempo-based effect” for reels animation.
Click capstan
to start/stop
reels animation