Manual

UAD Powered Plug-Ins Manual - 341 - Chapter 34: Precision Equalizer

Dual Mode In Dual mode (dual-mono mode), the left and right parameters can be inde-

pendently adjusted so that each side of the stereo signal can have different

EQ settings. Note that this mode is infrequently used during mastering be-

cause phase, imaging, and level inconsistencies may be induced in the result-

ing stereo signal.

Mode Selection

Any of the below methods may be used to modify the Mode value:

• Click the Stereo button to cycle through modes A and B

• Click the Dual button to activate dual-mono mode

• Click the indicator light above each mode

• Click+hold+drag the indicator light above each mode.

Parameter Copy

Buttons

The Parameter Copy buttons provide an easy method for copy-

ing parameter values. The behavior of the buttons is determined

by the current operating mode of Precision Equalizer.

Note: The values that existed at the destination before copying are lost.

Stereo Mode

When in Stereo mode (see “Stereo Mode” on page 340), clicking A > B cop-

ies the left AND right parameter values from parameter set A to parameter set

B, and clicking the A < B button copies all the values from parameter set B to

parameter set A.

This feature is useful when you want to make an EQ change to a stereo signal

while maintaining the original values so the two settings can be easily com-

pared.

Note: The high-pass filter parameter is global per preset and is not affected by

this control.

Parameter Copy in Dual Mode

When in Dual mode, the A and B buttons behave as left and right channel

copy buttons. Clicking A > B copies all the values from the left channel pa-

rameters to the right channel parameters, and clicking A < B copies all the val-

ues from the right channel parameters to the left channel parameters.