Manual

UAD Powered Plug-Ins Manual - 388 - Chapter 39: Pultec Passive EQ Collection
Artist Presets The Pultec Passive EQ Collection includes artist presets from prominent Pultec
users. Some of the artist presets are in the internal factory bank and are ac-
cessed via the host application’s preset menu. Additional artist presets are
copied to disk by the UAD installer so they can be used within Apollo’s Con-
sole application. The additional presets can be loaded using the Settings
menu in the UAD Toolbar (see “Using UAD Powered Plug-Ins” in Chapter 7 of
the UAD System Manual).
Note: Presets created with the original Legacy plug-ins are incompatible with
the equivalent newer model plug-ins.
Upsampling All UAD Pultec plug-ins use an internal upsampling technique. The upsam-
pling results in a slightly larger latency than other UAD plug-ins. See Chapter
9 “Delay Compensation” in the UAD System Manual for more information.
Pultec EQP-1A Controls
Control
Grouping
The EQP-1A can control three frequency bands simultaneously, using three
groups of interacting parameters.
The first group adjusts the low frequencies and has three controls: boost, at-
tenuation, and frequency select. The second group adjusts the high frequen-
cies and has three controls: boost, bandwidth, and frequency select. The third
group also adjusts the highs and has two controls: attenuation amount and
frequency select.
The placement and grouping of the sections and their related controls are
shown in Figure 118.
Figure 118. Control grouping within the Pultec EQP-1A