Manual

UAD Powered Plug-Ins Manual - 392 - Chapter 39: Pultec Passive EQ Collection
EQ Enable
This is the EQ enable control. Like the original hardware, the signal is
still colored even when this switch is in the out (down) position, be-
cause the signal is still passing through the I/O circuitry. If a true by-
pass is desired, use the Bypass/Gain knob (MEQ-5) or the Enable
switch (Pultec-Pro Legacy; see page 389).
Low Peak
Controls
LM Frequency
This switch determines the frequency of the low-midrange
portion of the equalizer. Five frequencies are available:
200, 300, 500, 700, and 1000 CPS.
Tip: To cycle through the available values, click the “PEAK”
text label, or shift+click the text label to cycle through avail-
able values in reverse. These shortcuts are unavailable with the Legacy ver-
sion of the plug-in.
LM Boost
This knob determines the amount of low-midrange gain to be
applied to the frequency set by the low-midrange frequency se-
lector.
Dip Controls Mid Frequency
This switch determines the frequency of the midrange portion
of the equalizer. Eleven frequencies are available: 200 CPS,
300 CPS, 500 CPS, 700 CPS, 1 KCS, 1.5 KCS, 2 KCS, 3
KCS, 4 KCS, 5 KCS, and 7 KCS.
Tip: To cycle through the available values, click the “DIP” text
label, or shift+click the text label to cycle through available values in reverse.
These shortcuts are unavailable with the Legacy version of the plug-in.
Mid Dip
This knob determines the amount of midrange cut (attenuation)
to be applied to the frequency set by the midrange frequency
selector.