Instruction Manual

UAD Powered Plug-Ins Manual - 178 - Chapter 13: Cambridge EQ

Cut Frequency

Knob

This knob determines the cutoff frequency for the Cut filters. The available

range is from 20 Hz – 5 kHz for the low cut filter, and 20 Hz – 20 kHz for

the high cut filter.

EQ Bands

All five of the EQ bands can be used in parametric or shelf mode. Each band

has identical controls, the only difference is the frequency range values.

The function of the controls is similar in both parametric and shelf modes. The

two modes are described separately (see “Parametric EQ” on page 179 and

“Shelf EQ” on page 182).

Enable Button Each band can be individually engaged with the Enable button. The button is

green when the band is enabled. All bands default to disabled. To enable

any band, click the Enable button.

You can use these buttons to compare the band settings to that of the original

signal, or to bypass the individual band. UAD DSP usage is slightly de-

creased when a band is disabled (unless “UAD-2 DSP LoadLock” on page

is enabled).

Frequency Knob This parameter determines the center frequency to be boosted or attenuated

by the Gain setting. The available range for each of the five bands is the same

for both parametric and shelf modes. The ranges are shown in T

able 14 on

page 179.

Figure 52. The EQ Band controls