User manual

UAD Powered Plug-Ins - 114 - Plate 140
Reverb Time
Meters
The Reverb Time Meters display the reverb time of
plates A, B, and C in seconds. The meter for the
active plate model (as specified by the Plate Se-
lect switch) is illuminated.
Note: The meter value can be changed by dragging its “needle” in addition
to its corresponding Damper controls.
Damper Controls
(Reverb Time)
The Damper Controls change the reverb time for
each plate. The range is from 0.5 to 5.5 seconds,
in intervals of 0.1 sec.
Click the buttons to increment or decrement the re-
verb time.
EQ
This group of parameters contain the controls for Plate 140’s
onboard utility equalizer. It is a two band (low and high) shelv-
ing EQ that uses analog-sounding algorithms for great tonal
shaping options.
The EQ section is independent from the reverb algorithms and
the low cut filter on the modeled plate systems. See “Cut Filter”
on page 118.
The frequency parameters specify the center of the transition
band, which is defined as the frequency at which the level in
dB is the midpoint between DC and the band edge level.
Note: There is one EQ per plugin instance. Each plate model (A, B, C) within
a preset cannot have unique EQ values.
EQ Enable
Switch
The Plate 140 equalizer can be disabled with the EQ Enable switch. UAD
DSP usage is not increased when EQ is enabled.