User's Manual

UniLink UL-800/801 FANS
SCN 30.X
Operator’s Manual
23-20-06.02 97
December 2011
Send an E-Mail
NOTE: Arrangement with DSP must be made for e-mail capability to
be available. Specific detailed instructions for email operation
may differ from the following procedure, depending on the
service provider.
1. With the TO line active, press [ENTER] to make the NO field
active.
2. Enter “E” in the first position of the NO field and press [ENTER].
3. In the free text area, enter the destination e-mail address. Use DA
for a dash (-), DOT for dot (.) and AT for at symbol (@). Delimit
the address with ST (Example: SCOTT AT AOL DOT COM ST).
Use spaces as indicated in the example and press [ENTER].
NOTE: The message will not send if symbols are used in place of text
(i.e., DA, DOT, AT).
NOTE: Spaces are placed in text using the plus/minus ( [ + ] ) key.
4. Enter the message text beginning on the next line after ST.
NOTE: If previously entered text is still in the Free-Text area, press
CLEAR, LSK [4L] before entering new text.
5. When finished editing the text portion of the message, press
RETURN, LSK [5R]. The entered text is displayed on the FREE
TEXT page for review with additional pages added as necessary.
6. Press SEND, LSK [4R] to place the message in queue for
transmission. A confirmation message will display if the e-mail is
sent successfully.
Send a Fax
1. On the FREE TEXT page, enter the fax recipient in the TO field
and press [ENTER].
2. In the NO field, enter the letter “F” followed by the destination fax
number with no spaces. Include: country code, area code, fax
number (Example: F17139434610) and press [ENTER].
3. Enter the message text in the free text area. When finished editing
the text portion of the message, press RETURN, LSK [5R]. The
entered text is displayed on the FREE TEXT page for review with
additional pages added as necessary.