User guide

To add devices to a scene, simply right-click a device, choose Add To Scene, and

choose the appropriate Scene. You can also hold the CTRL key down, click multiple

devices, then right-click and choose Add To Scene to add multiple devices at once.

If appropriate, the ISY will ask you if the device should be added to the Scene as a

Responder or a Controller. Some devices (typically devices without buttons) cannot be

Controllers.

To remove devices from a scene, simply right-click a device from within a scene and

choose Remove from Scene. To remove an entire scene, simply right-click the scene

and choose Remove Scene.

One example of a scene might be a group of 2 devices that control the same light –

typically called a “virtual 3-way circuit”. For example, you might have 2 switches in your

kitchen that you’d like to control your kitchen table light. One switch is physically

attached to the kitchen table light, but you’d like the other switch to control it as well. In

this case you would add both devices as Controllers. In the scene below, both devices

in the scene are Controllers (shown below in red). This is commonly called “cross-

linking”.