User guide

54
3.6 The Integrated IR Receiver
If your ISY came equipped with an integrated IR receiver (model numbers that contain
“/IR”), Programs can be triggered using an RC5-compatible remote control. To program
IR codes into the ISY, click the Configuration tab, then the IR sub-tab.
The IR configuration page lists all IR codes currently recognized by the ISY. The first
column titled “Name” allows you to customize the name of a stored IR code. Simply
double-click the IR code you’d like to change, and type the desired name. This is how
the IR code will be listed under ISY Program Conditions.
The “IR Code” is an internal number used to identify the IR code. It cannot be change
and for the most part should be ignored.
The “Status” column contains the last Condition received from a particular IR code. The
following conditions are available:
 Pressed – indicates the remote control button was pressed and released
normally.
 Double-Pressed – indicates the remote control button was pressed twice
quickly (similar to a mouse double-click).
 Held – indicates the remote control button was pressed and held (not yet
released).
 Released – indicates the remote control button was pressed and held, then
released.
The above Conditions are available in ISY Programs, allowing you to control your home
in a wide variety of ways from a simple remote control.
There are also 3 buttons on the bottom of the IR Configuration Page:
 Save – this button saves the currently displayed IR codes to the ISY.
 Reload – this button aborts any IR codes learned since the last Save, and
“reloads” the last saved IR database from the ISY.
 Restore Defaults – this button restores the ISY to its default, blank IR
database.