User guide
Table Of Contents
- Installation and setup
- Username/Password
- Automatically add new devices to HomeSeer
- Display Insteon type descriptions
- Split Location/Name from ISY name using character
- Set HomeSeer Location to
- Set HomeSeer Location 2 to
- ISY Insteon Plug-in Logging Level
- Update Device Types
- Remove Duplicates
- Save
- Status Message Filter
- Device Filter
- Advanced Feature
- ISY Insteon Plug-in Status Screen
- ISY Insteon Plug-in Thermostat Control
- Device Control
- Triggers
- Conditions
- Actions
- Thermostat API
- ISY Insteon API
- Tips
- Error Messages
- Warning Messages
In the list of interfaces, you should find the row for the ISY Insteon plug-in. It should look
similar to this.
If you have purchased the ISY Insteon Plug-in, press the “Unregistered” button to start the
registration process. If you have not yet purchased the plug-in, it will operate in trial mode for
30 days. If the “Online” registration fails, you can manually enter your license key and
password (supplied by HomeSeer).
Click the DISABLED button under the “Other” column in the ISY Insteon row. It will change to
a green “Enabled” button. Click the “Save” button to enable the ISY Insteon Plug-in.
HomeSeer will start the ISY Insteon Plug-in. The plug-in will attempt to locate an ISY on your
network. At this point you should see a gold “Config” button on the setup screen.
Click the gold “Config” button. This will bring up the ISY Insteon Configuration screen.