User's Manual

20 SIRIUS LCD Wireless Controller
Adding a Device by Entering Its
Code
You can add a device by manually
entering its manufacturer’s code. See
“Manufacturer’s Codes” on page 30.
To add a device by entering its code,
perform the following steps:
1. Press and hold SET until the
remote displays Initial Setup.
2. Press OK. The remote displays
Add Device. The bottom line of the
display lists Receiver as the first
device you can add. Either press
OK or press Scroll Left () or
Scroll Right () to select another
device to add.
3. Enter the four-digit code for your
device. The LED blinks once for
each digit entry. It blinks twice
after the you have entered the
final digit. See “Manufacturer’s
Codes” on page 30.
NOTE: If an invalid code is entered,
the LED emits one long blink, and
the LCD displays Invalid.
4. The selected device turns off if
the code was successful.
5. Press OK to save the code.
Using Learning
If you cannot find your device code,
you can use your SIRIUS LCD
wireless controller to learn functions
from other remote controls.
NOTE: SIRIUS mode is not valid for
learning.
NOTE: Please have your original
remote controls handy before
programming learning.
NOTE: You must add the device you
want to learn first (for example,
Receiver). If you cannot find a
code that works with your device
(for example, Receiver), enter a
"dummy" code (any four-digit
code) so that RCV is an available
device. That device is available
for your wireless controller to
learn.
1. From ADVANCED SETUP press
Scroll Left () or Scroll Right
() to find LEARN FUNCTION. Press
OK.
2. The remote displays Add Learn
Key. Press OK.
3. The remote displays FIND MODE TO
LEARN  PUSH OK. The bottom line
of the LCD displays the device
type (for example, Satellite).
Press Scroll Left () or Scroll
Right () to select another
device (mode) to learn. Press OK.
4. The remote displays Align Remotes
PUSH OK. Place the two remotes as
shown in the diagram below and
on the display. Press OK.
5. The remote displays SELECT THE
KEY TO LEARN. Press any key you
want to learn on your wireless
controller except SET, SIRIUS,
OK, Scroll Left () or Scroll
Right ().
6. The remote displays WHEN
BACKLIGHT TURNS OFF PUSH TEACHING
KEY. The backlight turns off. The
display reads LEARNING NOW!
PRESS TEACHING KEY. Press the
teaching key on the original
remote control.
7. If Learning is successful, then
display and backlight turn back
on. The remote displays SUCCESS!
PUSH OK TO LEARN PUSH SET TO EXIT.
8. Press OK to learn another key or
press Set to exit Learning mode.
If you press OK, the remote
2"
SIRIUSRadio.book Page 20 Sunday, September 17, 2006 2:24 PM