User's Manual

SIRIUS LCD Wireless Controller 21
returns to step 5 above and learns
another key.
NOTE: If learning fails, the display
reads LEARNING FAILED PUSH OK TO
LEARN PUSH SET TO EXIT. Possible
causes for learning failure:
• Learning close to a UV source
(i.e. in sunlight, or close to fluo-
rescent lighting)
• Your remotes are too far apart.
• Each learning remote is an RF
remote. Remotes must be IR
(infrared).
• The remotes’ IR LEDs are not
aligned.
Deleting All Learned Keys
To delete all learned keys, perform the
steps below:
1. From ADD LEARN KEY press Scroll
Left () or Scroll Right () to
find DELETE LEARN KEY. Press OK.
2. The wireless controller displays
SELECT MODE THEN PUSH OK. On the
bottom line 3 the device name is
displayed (for example, TV). Press
Scroll Left () or Scroll Right
() to cycle through the available
modes. Press OK.
3. The wireless controller displays
Select Key to Delete or Push OK
to Delete All.
4. Press OK. The wireless controller
displays DELETING ALL PUSH OK TO
CONFIRM. PUSH OK. The
wireless controller displays All
Learned Keys Deleted. Push OK to
Delete More.
Deleting a Single Learned Key
To delete a single learned key, follow
steps 1–3 above. Then perform the
following steps:
1. Press the key containing the
learned function to be deleted.
The remote displays KEY DELETED
PUSH OK TO DELETE ANOTHER.
2. Press SET to exit or press OK to
delete another learned key
function.
Choosing Your Audio
Source
If you have an audio receiver or
amplifier with multiple inputs, you can
program your remote control to
automatically select one of its inputs
as an audio source for your SIRIUS
Satellite Radio.
To choose your audio source, perform
the following steps:
NOTE: Any key learning for your
audio device must be performed
before you choose your audio
source.
1. From ADVANCED SETUP use
SCROLL LEFT and SCROLL
RIGHT to find SET AUDIO SOURCE
FOR SIRIUS. Press OK.
2. If two radios are programmed,
then remote displays OK FOR RADIO
1 < > FOR RADIO 2. Press OK.
3. Press OK to access the
programming for Radio 1, or
press Scroll Left (
) or Scroll
Right () to access Radio 2.
NOTE: If you only have one radio, skip
step 3 above and proceed to the
next step.
4. The remote displays SELECT AUDIO
DEVICE AND PUSH OK. Press Scroll
Left () or Scroll Right () to
find the audio device that your
Sirius radio is plugged into. The
name of the device is displayed
(for example, Receiver).
5. The remote displays NOW PUSH OK
TO FIND INPUT FOR RADIO 1. (If you
have two radios, the remote
displays NOW PUSH OK TO FIND INPUT
FOR RADIO 2.) Press OK.
6. The remote displays PUSH OK
WHEN YOU FIND YOUR INPUT. The
SIRIUSRadio.book Page 21 Sunday, September 17, 2006 2:24 PM