User's Manual

26 SIRIUS LCD Wireless Controller
Scroll Right (), and OK to store
your macro.
4. The remote displays ENTER THE
MACRO SEQUENCE. Press OK.
5. You can enter up to 30
commands for your macro
sequence. Press Scroll Left ()
or Scroll Right () to find the
mode for each command. Each
mode is displayed on the bottom
line of the LCD. To end the Macro
in a specific mode, then select the
specific mode and press OK as
the last step
NOTE: SIRIUS is an invalid mode key
for macros.
6. As you enter the keys for your
macro, the remote displays PUSH
OK FOR 3 SECONDS TO SAVE. Press
and hold OK for three seconds to
save your macro. The remote
displays available mode keys on
the bottom line of the LCD so you
can easily select the appropriate
ones for your macro.
7. The remote displays Macro Saved
and returns to the Key Macro
screen.
NOTE: If you enter more than 30 keys
into the macro, the remote
displays Memory Full.
Deleting a Key Macro
You can delete a key macro from the
wireless controller’s programming. To
delete a key macro, perform the
following steps:
1. From ADVANCED SETUP press
Scroll Left () or Scroll Right
() to find KEY MACRO. Press OK.
2. The remote displays ADD KEY
MACRO. Press Scroll Left () or
Scroll Right () to scroll to
DELETE MACRO. Press OK.
3. The remote displays SELECT
MACRO KEY TO DELETE AND PUSH OK.
4. Once you have selected a valid
macro key, the remote displays
MACRO DELETED CHOOSE ANOTHER OR
OK TO EXIT.
5. Repeat steps 2–4 above until you
have finished deleting key
macros. Press SET when
finished, to return to normal
operation.
Setting the Contrast of
Your Wireless Controller’s
LCD Display
You can control and set the contrast
settings of your LCD display. To set
the display’s contrast, perform the
following steps:
1. From ADVANCED SETUP, press
Scroll Left () or Scroll Right
() to find CONTRAST. Press OK.
2. The LCD displays CONTRAST
SETUP, with 10 blocks to show the
CONTRAST setting. Press Scroll
Left () or Scroll Right () to
adjust the setting ( to raise
CONTRAST, to lower CONTRAST).
Adjusting the LCD Timer
You can adjust the LCD timer to
control how long your display runs
before it times out and goes blank.
You can adjust the timer in increments
of 10, 20, or 30 seconds.
NOTE: This does not affect backlight
settings. The backlight runs for 10
seconds on your display, and 5
seconds on your keypad.
To adjust the LCD Timer, perform the
following steps:
1. From ADVANCED SETUP, press
Scroll Left () or Scroll Right
() to find LCD Timer. Press OK.
2. The LCD displays SET TO 20
SECONDS (or the timer of the last
active setting). Press Scroll Left
() or Scroll Right () to adjust
the LCD Time-out period.
SIRIUSRadio.book Page 26 Sunday, September 17, 2006 2:24 PM