User's Manual

SIRIUS LCD Wireless Controller 27
3. Press OK to save. The wireless
controller’s LED blinks twice, and
LCD returns to LCD TIMER.
About
The About screen displays information
about the wireless controller and the
radio. You can find software version
information about the wireless
controller and the radio using this
mode.
Resetting Programming
Resetting All Features
You can reset all the remote’s
programming, including Key Mover,
Key Macro, Learning, and Volume
Lock, except for device codes. To
reset all programming, perform the
following steps:
1. From ADVANCED SETUP press
Scroll Left () or Scroll Right
() to find RESET REMOTE. Press
OK.
2. The remote displays TO RESET ALL
FEATURES PUSH OK. Press OK.
3. The remote displays PUSH OK TO
CONFIRM OR SET TO CANCEL. Press
OK.
4. The remote displays Reset
Confirmed.
Restoring Programming to
Factory Settings
To reset the remote to its factory
settings, perform the following steps:
NOTE: This will remove all devices
you have programmed, so use
caution when restoring factory
settings.
1. When the remote displays TO
RESET ALL FEATURES PUSH OK, press
Scroll Left () or Scroll Right
() until the remote displays
RESET TO FACTORY SETTING PUSH OK.
Press OK.
2. The remote displays PUSH OK TO
CONFIRM OR SET TO CANCEL. Press
OK.
3. The remote displays THIS CLEARS
ALL EVEN CODE SETUP ARE YOU SURE?
Press OK.
4. The remote displays Reset
Confirmed. Your remote is now
reset to its original factory
programming.
Setting Up a ZWAVE
Network
Network Reset
Use Network Reset if you change
radios and need to pair a previously
paired remote with a new radio that
has never been paired. This could be
necessary if your radio stops working
and you need to replace it, and intend
to use the same SIRIUS LCD Wireless
Controller with the new radio. Before
pairing the wireless controller with the
new radio, you must reset the network.
To use Network Reset, perform the
following steps:
1. Press and hold SET until the LCD
displays Initial Setup.
2. Press Scroll Left () or Scroll
Right () to get to SIRIUS
SETUP. Press OK.
3. The LCD displays NODES. Press
Scroll Left () or Scroll Right
() to get to NETWORK.
4. The LCD displays NETWORK RESET.
Press OK.
5. The LCD displays WAITING,
indicating that Network Reset is in
progress.
6. The LCD displays Successful
when the network has been reset.
SIRIUSRadio.book Page 27 Sunday, September 17, 2006 2:24 PM