User's Manual

To set this up :
1. Connect any combination of up to 6 IR Emitters (one
for each device to be controlled, sold separately), Nevo
Serial Modules (sold separately) or Nevo sensing
devices (sold separately) to the programmable ports on
NevoConnect NC-50’s rear panel.
Installer Tip: Serial and sensing devices must be plugged
into the port that was assigned to them as part of the device
setup in NevoStudio Pro.
2. Connect the other end of the Nevo IR Emitter, Nevo
Serial Module, or Nevo sensor to the devices to be
controlled. For Nevo IR Emitters, peel off the paper
from the adhesive label and stick the IR transmitter
directly on top of the device’s IR receiver.
3. Connect the power adapter to NevoConnect NC-50’s
rear panel, then to a power outlet.
Connecting to a Z-Wave Network
Installer Tip:
Make all connections (such as IR emitters,
sensors, or serial modules) before you plug in the power
adapter.