User's Manual

2. Press and hold the program button on NevoConnect
NC-50 for 10 seconds (until you see the Power LED
blink twice).
3. Press Program on the Controller that is to be the new
Primary Controller.
4. When the process is complete, the Power LED will blink
twice then remain on. The duration of the blinks
indicates if the process was successful, just as in the
Add/Remove NevoConnect NC-50 process.
You can confirm that Nevo is now the Primary
Controller by selecting the Z-Wave option from the
Settings menu.
Soft Reset
To initiate a soft reset of NevoConnect NC-50 hardware,
press the reset button on the bottom panel. You will see
the Power LED blink.
Factory Reset
WARNING:This action will reset NevoConnect NC-50 to
its unconfigured state and remove it from the Z-Wave
network. NevoConnect NC-50 will be unable to
communicate on the current Z-Wave network.
To factory reset, follow these steps:
1. Unplug NevoConnect NC-50.
2. While pressing and holding the reset button, plug in
NevoConnect NC-50.
3. Continue to hold down the reset button for 10 seconds
(until you see the Power LED blink).
4. Factory reset is complete when the power indicator no
longer blinks.