User's Manual

RESTAURAR VALORES PREDETERMINADOS DE FÁBRICA Y RESTABLECER EMPAREJAMIENTO RF.
Restablecer el mando a los valores predeterminados de fábrica,
- Si ya están emparejados, enviar una solicitud de desemparejar de STB, y borrar la información de
emparejamiento.
- Todos los ajustes de Quickset han sido borrados.
- Configuración de TV universal ha sido borrado, para regresar a los códigos de IR por defecto.
- Los ajustes de retroiluminación y encontrar mando vuelven a los valores predeterminados y
comportamiento.
Secuencia de Programación:
<<LIVE TV + Rewind>> -> Mantener presionadas estas teclas por más de 5 segundos
Si emparejamiento fue un éxito: (La tecla de encendido en STB parpadeará 4 veces el cual
indica éxito)
Si emparejamiento ha fallado: (La tecla de encencido de STB, mostrará un parpadeo de
error)
COMPLIANCE WITH FCC RULES AND REGULATIONS
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and if not used in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, the user is
encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase or decrease the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
 Consult the dealer or an experienced remote control/ TV technician for help.
The user is cautioned that changes and modifications made to the equipment without the
approval of manufacturer could void the user's authority to operate this equipment.
FCC Authorization Label
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
1. This device may not cause harmful interference.
2 This device must accept any interference received, including interference that may cause
undesired operation.