User's Manual

Recovering Your Picture

Use the RECOVER button to get back to

watching satellite programming if you accidentally

change channels or inputs on your TV, DVD, and/

or VCR. To use this feature, you must set up

Auto-Tune for your TV (see page 16) and for your

DVD/VCR (see page 18).

Note: RECOVER only works if the remote control has been

set up to control the TV and/or DVD/VCR, if connected. If

the RECOVER button is used, the TV channel programmed

for SAT Auto-Tune is also the channel that is sent to the

TV. RECOVER rst tries to tune your TV to channel 3, then

channel 4, and then other video inputs with each press of the

RECOVER button. You may need to press the RECOVER

button up to 30 times to recover your satellite TV video.

Press and hold RECOVER

until all Mode buttons light up.

If you see the System Info

screen, proceed to step 4.

Otherwise, continue to step 3.

Press RECOVER again and

wait until the Mode lights

stop ashing. If you see the

System Info screen, go to

step 4. If not, repeat this step

until you see the screen.

Press SELECT to resume

watching TV.