User's Manual

Ensure the DISH Network remote control is

programmed to the desired remote address

(see page 4 or 5).

Place both the DISH Network remote and the

original device’s remote control on a at, stable

surface. Point the front of the original device’s

remote to face the small square (IR window) on the

front, left-hand side of the DISH Network remote, as

shown below. The remotes should be no more than

3” apart.

On the DISH Network remote, press and hold the

Mode button you want to use for the device until

all the Mode buttons light up (approximately three

seconds), and then release it. The selected Mode

button blinks continuously.

To start learning commands for this mode, select

one of the following choices:

• If you’ve found a code for the device, rst

program the code using the instructions for

Entering a Code on page 11 or Scanning the

Remote Database on page 13. If the device

code has been programmed, press and release

RECALL (the Mode light goes off when

RECALL is pressed and comes on when

released), then hold the RECORD button

until the Mode button is lit again (about three

seconds). The Mode button remains lit while

learning.

• If the device code has not been programmed for

that device or if you are unable to nd a code,

press and hold the RECORD button until the

Mode button is lit (about three seconds). The

button remains lit while learning.

Learning from Another

Device’s Remote, continued