User's Manual
25
Troubleshooting, continued
When you try to enter TV programming mode, all
the mode LEDs ash.
What to do: Replace the batteries (see page 2).
Your remote control does not work well.
What to do: Move your receiver to different
locations. For best results, place the receiver as
high as possible, above all other equipment in your
entertainment center. There may be IR interference
from objects near the receiver.
Your remote control seems to have stopped
working.
What to do: Press one or more buttons on the
remote to wake the remote control. The remote
control may have gone to sleep to reduce battery
drain. If your remote is still unresponsive, take out
the batteries and press any button for three seconds,
then reinsert the batteries.
Your picture is snowy (or black or blue).
What to do: Make sure your TV is tuned to the
correct channel. You may have accidentally changed
the channel on your TV. Check the Reference Table
to see what channel your TV is tuned to.
When you press the remote control MUTE or
VOLUME button, nothing happens.
What to do: Program the remote to control your TV.
See Programming Remote to Control Another Device
on page 11. If you are trying to control TV volume, but
the remote is set up to control a tuner or amplier in
AUX mode, then see Control TV Volume on page 20.
The receiver does things even though you haven’t
pressed any remote control buttons.
What to do: Check the System Info screen to
view a list of remotes linked to your receiver. Unlink
the unwanted remote controls from this screen.
See Avoiding RF Interference on page 18 for more
information.