User's Manual

Learn
Learning Style
Add learned commands to existing code
Blank Slate-This will erase all previous commands
Start Learning
15
Using the on-screen keypad,
enter the four-digit code for
your device. Select Next.
Note: The three-digit device
codes used by other DISH
remote controls cannot be
used.
Select Yes to save the code.
Conrm that the code you
entered appears for the
programmed device (TV
or AUX) on the Remote
Manager settings screen.
Press the Mode button
for the device you are
programming (TV or AUX).
Press POWER. If device
does not turn off, press
to switch modes. Try
entering the code again. If
device turns off, continue to
step 10.
Using the remote, turn the
device back on and try some
other remote buttons to see
if they work.
Repeat steps 1 through 10
until you have the best code
for controlling your device.
Programming Remote to Control
Another Device, continued
Learning Codes
Turn the device and
receiver on.
Press MENU and select
the Settings tile. From the
Settings screen, select
Remote Manager.
Select the TV Code or AUX
Code option on the Remote
Manager settings screen,
depending on the device
that you want the remote to
learn from.
Select Learn.
Select Learning Style.
Select Add learned
commands to existing
code if you want to
program specic buttons.
Select Blank Slate—This
will erase all previous
commands if you want to
program most of the remote
codes into your 40.0 remote.
Select Start Learning.
1
2
3
4
5
6
Another way to program codes from one remote to
another is the Learning Codes procedure.
Programming Remote to Control
Another Device, continued