User's Manual

Save
Volume
Control Volume for
TV
AUX
21
Ensure the UHF-2G remote
antenna is connected to the correct
input on the Hopper receiver’s back
panel and is not touching anything.
Tighten only by hand.
Vary the tilt angle of the Hopper
receiver’s remote antenna, locating
the antenna’s tip away from any
other electronic equipment or metal
surfaces, even if separated by
wooden shelving.
Move the receiver to a different
location. Place it on as high a
surface as possible, above all other
equipment in your entertainment
center.
Use the optionally available special
extension cable to connect the
remote antenna to the Hopper
receiver and place it away from
other equipment.
Move any nearby antenna or radio
equipment away from the Hopper
and/or the Joey receiver. Do not
place an over-the-air antenna, WiFi,
Bluetooth®, or ZigBee® devices on
or near the receivers.
Control Amplier Volume
When the remote is set up to operate your TV, the
MUTE and VOLUME buttons adjust your TV volume
when in SAT mode. When the remote is also set up
to operate a remote-controllable audio receiver or
amplier (usually in AUX Mode), use these steps to
program the remote to control the amplier’s volume.
Press HOME, select
Settings tile, and then
select Remote Manager.
Select Volume.
Under Control Volume for,
highlight the AUX option.
Select Save.
1
2
3
4
5
6
7
Makesuretheremotecontrolstheamplier’s
volume in other modes:
Press SAT.
Press the plus (+) and minus
(-) sides of the VOLUME
button.
Your tuner/amplier’s volume
changes, and the AUX mode
button lights.