Owner's Manual Part 1

2. Locate the two (2) enclosed AA batteries.

Match the + and - marks with those in the

battery case, then insert them.

3. Align the cover’s keys with the case’s holes and

press the cover back into place. The tab should

click when the cover is locked.

NOTE: When batteries need replacement, the remote

control ceases to operate. Replace the

batteries and the unit is restored to its full

functionality, complete with your favorite

settings.

IF YOU HAVE MORE THAN ONE SATELLITE

RECEIVER

Your remote control address is set at the factory to 0000

to control all of the functions on your Motorola satellite

receiver. However, if you have more than one satellite

receiver, you may want to prevent the remote control in

one room from affecting the satellite receiver in another

room. To prevent this kind of interference, you must

“pair” each remote control with each receiver by

assigning a new “address” to each combination. This

“address” assignment is made using your remote control

as follows:

1. Turn on the TV.

4. Test the remote control by pressing any mode

key (e.g., TV). If the batteries are inserted

correctly, the LED (red light) blinks once.

2. Press the SAT key to select the remote control’s

SAT mode.

3. Press the Options key to display the Options

screen on your TV.

4. On the Options screen, use the S, T, W, X

keys to highlight the Change System Settings/

System Setup option, then press ENTER.

5. On the Systems Setting /Setup screen, use the

S, T, W, X keys to highlight the Change

Installation Settings/System Settings option,

then press ENTER. (Applies to DSR 5xx, 207,

317 receivers.)

Motorola 551 IR_IR-UHF Rev 2.3.fm Page 10 Friday, May 26, 2006 12:27 PM