User's Manual
Table Of Contents
- ATLAS DVR/PVR IR/UHF
- Remote Control
- Télécommande ATLAS ENP IR/UHF
- Users Guide
- Guide d'utilisation
- TABLE OF CONTENTS
- Introduction
- Features and Functions
- Installing Batteries
- Programming Device Control
- Programming TV/VCR Combo Control
- Searching for Your Code
- Checking the Codes
- Using Learning
- Programming Channel Control Lock
- Changing Volume Lock
- Using the Master Power Key
- Re-Assigning Device Keys
- Checking Your Remote’s ID Code
- Changing Your Remote’s ID Code
- Using Your Remote’s RF Functionality
- Clearing Custom Programming
- Troubleshooting
- FCC Notice
- Additional Information
10
Device Type:___________________
DVD Code
Device Type:___________________
AUD Code
Device Type:___________________
MTS Code
Device Type:___________________
TV Code
Device Type:___________________
PROGRAMMING TV/VCR COMBO CONTROL
If you own a TV/VCR Combo, perform the following
instructions to control this device:
1. Turn on your TV/VCR Combo and insert a
video cassette.
3. Use the “Manufacturer’s Codes (Codes Des
Fabricants)” starting on page 54 to locate the
brand name and enter the first four-digit code
for your TV/VCR Combo. If you perform this
procedure correctly, the AUX key blinks twice.
NOTE: If the AUX key did not blink twice after enter-
ing the codes last digit, repeat steps 2 through
3 and try entering the same code again.
If you’ve located a TV/VCR setup code that
works for your TV/VCR Combo and a separate
TV code is also listed, you’ll need to program
this code into the remote control to access vol-
ume control (see “Programming Device Con-
trol” starting on page 9).
2. On the remote control, press AUX once; it
blinks once. Then press and hold SETUP until
the AUX key blinks twice.