User's Manual
Table Of Contents
- ATLAS DVR/PVR IR/UHF
- Remote Control
- Télécommande ATLAS ENP IR/UHF
- Users Guide
- Guide d'utilisation
- TABLE OF CONTENTS
- Introduction
- Features and Functions
- Installing Batteries
- Programming Device Control
- Programming TV/VCR Combo Control
- Searching for Your Code
- Checking the Codes
- Using Learning
- Programming Channel Control Lock
- Changing Volume Lock
- Using the Master Power Key
- Re-Assigning Device Keys
- Checking Your Remote’s ID Code
- Changing Your Remote’s ID Code
- Using Your Remote’s RF Functionality
- Clearing Custom Programming
- Troubleshooting
- FCC Notice
- Additional Information
19
NOTE: Only one device can be assigned to an unused
device key at a time.
To re-assign another unused device key, substitute it for
the AUX key above and then perform the sequence. For
example, to re-assign an unused AUD key as a second
DVD key, perform
AUDÆSETUPÆ9Æ9Æ2ÆDVDÆAUD.
When a re-assignment is done, the selected device key
(e.g., AUD) blinks twice to confirm your choice. At that
time, you need to program device control (see
“Programming Device Control” on page 9).
CHECKING YOUR REMOTE’S ID CODE
In order to use your Atlas DVR/PVR IR/UHF Remote’s
RF functions, the remote must have an ID code of 1, 2,
or 3. In order to control your MTS Set-top Box using IR,
your remote must have an ID code of 0. To check your
remote’s ID code, perform the following steps:
To Re-Assign Perform Key Sequence
AUX as 2nd
AUD key
AUXÆSETUPÆ9Æ9Æ2ÆAUDÆAUX
AUX as 2nd
TV key
AUXÆSETUPÆ9Æ9Æ2ÆTVÆAUX
AUX as 2nd
MTS key
AUXÆSETUPÆ9Æ9Æ2ÆMTSÆAUX
AUX back to
AUX
AUXÆSETUPÆ9Æ9Æ2ÆAUXÆAUX
1.
‘
Press MTS once. Then press and hold SETUP
until MTS blinks twice.
2. Enter 9 5 6.
3. Press 1 once. Count the number of times the
MTS key blinks (e.g., 3 blinks = 3). The
number of blinks is your remote’s ID code.