User's Manual
Table Of Contents
- ATLAS DVR/PVR IR/UHF
- Remote Control
- Télécommande ATLAS ENP IR/UHF
- Users Guide
- Guide d'utilisation
- TABLE OF CONTENTS
- Introduction
- Features and Functions
- Installing Batteries
- Programming Device Control
- Programming TV/VCR Combo Control
- Searching for Your Code
- Checking the Codes
- Using Learning
- Programming Channel Control Lock
- Changing Volume Lock
- Using the Master Power Key
- Re-Assigning Device Keys
- Checking Your Remote’s ID Code
- Changing Your Remote’s ID Code
- Using Your Remote’s RF Functionality
- Clearing Custom Programming
- Troubleshooting
- FCC Notice
- Additional Information
24
FCC NOTICE
This equipment has been tested and found to comply
with the limits for a class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy
and if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV
technician for help.
• It is strongly recommended that the TV be plugged
into a separate wall outlet.
This equipment has been verified to comply with the
limits for a class B computing device, pursuant to FCC
Rules. In order to maintain compliance with FCC
regulations, shielded cables must be used with this
equipment. Operation with non-approved equipment or
unshielded cables is likely to result in interference to
radio and TV reception. The user is cautioned that
changes and modifications made to the equipment
without the approval of manufacturer could void the
user’s authority to operate this equipment.
FCC ID: MG32150