User's Manual
Table Of Contents
- ATLAS DVR/PVR IR/UHF
- Remote Control
- Télécommande ATLAS ENP IR/UHF
- Users Guide
- Guide d'utilisation
- TABLE OF CONTENTS
- Introduction
- Features and Functions
- Installing Batteries
- Programming Device Control
- Programming TV/VCR Combo Control
- Searching for Your Code
- Checking the Codes
- Using Learning
- Programming Channel Control Lock
- Changing Volume Lock
- Using the Master Power Key
- Re-Assigning Device Keys
- Checking Your Remote’s ID Code
- Changing Your Remote’s ID Code
- Using Your Remote’s RF Functionality
- Clearing Custom Programming
- Troubleshooting
- FCC Notice
- Additional Information
7
Device Table
NOTE: Please refer to the table below when
performing the instructions in
“Programming Device Control” on page 9 or
“Programming TV/VCR Combo Control” on
page 10.
After programming, theAtlas DVR/PVR IR/UHF
Remote can control the following types of devices:
Use PIP ON-OFF to switch the Picture-
In-Picture feature on or off (if available
on your TV).
Use PIP SWAP to switch images and
sound between the main and window
pictures.
U
se
PIP MOVE
to move the window picture
to different positions in the main picture
.
Use PIP CH+ (or CH-) to select the next
higher (or lower) PIP channel.
In the MTS mode, use VIDEO SOURCE to
view other video sources (A or B)
instead of cable.
In all other modes, use VIDEO SOURCE
to watch TV or video programs on a
desired device.
For amplifiers/receivers, use VIDEO
SOURCE to select an input source.
Device Key Controls these types of devices
VCR, TV/VCR Combo, PVR (Personal
Video Recorder), or extra DVD Player
DVD Player
Audio Amplifier, Tuner, or Receiver
Television
MTS Set-top Box
Key Function