User's Manual

17
Multi-Box Setup
To program your remote to control 3 or more DIRECTV
Receivers in one room:
1. Turn on your TV and DIRECTV Receiver.
2. Slide the MODE switch to the DIRECTV position.
3. Press MENU on your remote control, then select
“Parental, Fav's & Setup,” “ System Setup,” a n d
“Remote Control.”
4. Select “Program Remote.”
5. Select “Advanced.”
6. Select “Multi-Box Setup.”
Follow the on-screen instructions to complete the process.
CONTROLLING YOUR TV
Once you have successfully set up your DIRECTV Remote
to operate your DIRECTV Receiver, you can set it up to
control your TV. We recommend you use the on-screen
steps described on page 8, but you can also use the
manual method below:
1. Turn on the TV.
NOTE
: Please read steps 2-5 completely before proceed-
ing. Highlight or write down the codes and com-
ponent you wish to set up before moving on to
step 2.
2. Locate the 5-digit code for your TV. (See “Setup
Codes for TVs” on page 24.)
3. Slide the MODE switch to the TV position.
4. Press and hold the MUTE and SELECT keys at the same
time until the green light under the TV position
flashes twice, then release both keys.
5. Using the number keys enter the 5-digit code for your
brand of TV. If performed correctly, the green light
under TV flashed twice.
6. Aim the remote at your TV and press the PWR key
once. Your TV should turn off. If it does not turn off,
repeat steps 3 and 4, trying each code for your brand
until you find the correct code.
7. Slide the MODE switch to the DIRECTV position. Press
TV POWER. Your TV should turn on.
8. For future reference, write down the working code for
your TV in the blocks below:
DIRECTV RC65RBX.fm Page 17 Sunday, March 28, 2010 6:56 PM