User's Manual

FCC Compliance Statement
This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC rules.
These limits are designed to provide reason-
able protection against harmful interference
in a residential installation. This equipment
generates, uses, and can radiate radio fre-
quency energy and, if not used in accordance
with the instructions, may cause harmful
interference to radio communications.
There is no guarantee that interference will
not occur in a particular installation. If this
equipment does cause harmful interference
to radio or television reception, the user is
encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving
antenna.
• Increase or decrease the separation
between the equipment and receiver.
• Connect the equipment into an outlet
on a circuit different from that which
the receiver is connected.
• Consult the dealer or an experienced
remote control/TV technician for help.
• It is strongly recommended that the TV
be plugged into a separate wall outlet.
The user is cautioned that changes and mod-
ications made to the equipment without the
approval of the manufacturer could void the
user’s authority to operate this equipment.
This device complies with part 15 of the FCC
rules. Operation is subject to the following
two conditions: (1) This device may not cause
harmful interference, and (2) this device must
accept any interference received, including
interference that may cause undesired
operation.
:Q Can I pair more than one Xnity
Remote with the XR8?
:A Yes, the XR8 supports pairing
with up to ve Xnity Remotes.
:Q Why can’t I use my other
remotes after pairing my Xnity
Remote with the XR8?
:A Some set-top boxes only
support Xnity Remotes when
using the XR8. Simply replace
your old remote with another
Xnity Remote if you need more
than one remote!
:Q During pairing, why does the
LED blink red and then green on
the Xnity Remote?
:A Either a button other than the
Xnity button was pressed, or
the Xnity Remote timed out
before the Xnity button was
pressed. Repeat the pairing
steps.
COMPATIBLE
DEVICES:
DTA
uDTA
RNG100
RNG110
RNG150
RNG150N
RNG200N
DCX3200
DCX3200-M
DCX3400
DCX3400-M
DCX3501
FREQUENTLY ASKED
QUESTIONS ABOUT PAIRING
:Q During pairing, why does the LED
blink red, then green, then red on
the Xnity Remote?
:A The Xnity Remote you are trying
to pair with the XR8 cannot nd
the XR8. Unplug the XR8 and plug
it back in, making sure the red
LED on top of the XR8 comes on
for 3-5 seconds. Then, repeat the
steps to pair the XR8 and Xnity
Remote.
:Q When paired, why does the LED
blink green, then red on the
Xnity Remote when a button is
pressed?
:A The XR8 may have lost power or
may be out of communication
range. Try moving closer to your
set-top box or DTA and make sure
the XR8 is securely connected. If
this does not x the issue, follow
the steps to re-pair the XR8 and
Xnity Remote.
SET-TOP BOXES AND DTAS
The XR8 can be used for out-of-sight
control with the set-top boxes and
DTAs listed below:
XFINITY REMOTES
Xnity Remotes that can be paired
with the XR8 include:
XR2
XR5
XR11
XR13
For additional information
about Xnity Remotes visit
xnity.com/remotes.