User's Manual

Manually pair TV with Remote Control

This allows the user to set up a 4-digit code for a particular TV brand. Note that the

programming mode can only be accessed from keyboard side.

1. Locate your TV’s 4-digit code in the ‘Setup Code Table’

2. Flip your remote so the keyboard side is facing upward.

3. Press and hold ‘Menu’ and ‘Enter’ at the same time for five seconds. (see Figure 1)

4. Enter your TV’s 4-digit code

5. Press ‘Volume Up’ or ‘Volume Down’ to confirm the TV is paired to the remote. If your

TV is not paired, try again with another code for your TV brand.

Backlight User Feedback:

• Blink error, exit programming state, and restore the last preprogrammed code if:

- After <<ENTER + MENU>> any key is pressed besides a digit keys.

- After last digit if it is an invalid device code.

• The unit shall exit programming state and return to the last preprogrammed code if

programming timeout has elapsed between digit entries.

• Two blinks after last digit to confirm that a valid code has been programmed, and return

back to normal operation.

Figure 1

Controlling your WebTuner Set-Top Box

Your WebTuner Remote is fully compatible with your WebTuner STB. If your remote is not

working, please check the batteries or view ‘Pair WebTuner Set-Top Box with Remote’. Use

Figures 2 and 3 to familiarize yourself with the remote keys.