User's Manual

Caring for Nevo

Q50

Use only the stylus to switch Nevo

Q50

on or off. Avoid using sharp objects.

lean your remote with a soft, damp cloth using a gentle, non-caustic cleaner

CAUTION:Do not use a caustic or abrasive cleaner. This may damage the

surface of your controller.

For more information, contact

your installer/integrator:

NOTICE:

Nevo, NevoStudio, Nevo

Q50

, NevoStudio Pro and NevoConnect are registered

trademarks or trademarks of Universal Electronics Inc., in the United States and/or other

countries. Other product and company names may be trademarks of their respective

companies.

FCC NOTICE: This equipment has been tested and found to comply with the limits for a class B

digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide a reason-

able protection against harmful interference in a residential installation. This equipment gener-

ates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with

the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this

equipment does cause harmful interference to radio or television reception, which can be deter-

mined by turning the equipment off and on, the user is encouraged to try to correct the interference

by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet or a circuit different from that to which the receiver is

connected.

• Consult the dealer or an experienced radio/TV technician for help

Operation is subject to the following two conditions: (1) this product may not cause harmful inter-

ference, and (2) this product must accept any interference received, including interference that

may cause undesired operation.

This equipment has been verified to comply with the limits for a class B computing device, pursu-

ant to FCC Rules. In order to maintain compliance with FCC regulations, shielded cables must be

used with this equipment. Operation with non-approved equipment or unshielded cables is likely

to result in interference to radio and TV reception. The user is cautioned that changes and modifi-

cations made to the equipment without the approval of the manufacturer could void the user’s

authority to operate this equipment.

FCC ID: MG362400

IC ID: 2575A-URC6240

Installer/integrator: attach your

business card or business

sticker here.

Document version NQ50QGP101007