Quick Start Guide

ManualsBrandsUniversal Electronics ManualsElectronicsBLUETOOTH REMOTE CONTROL

ComcastPlatcoTVRemote2020

ComcastQuickStartGuide

ACTIVATINGRF



QuickSet

This product shall support the following features:

 Auto Setup

 Manual Setup

 Optimized Setup Maps (OSM)

The following are descriptions of the Quickset features:

Auto Setup: Quickset allows for auto setup of the RCU by identifying devices connected through the

HDMI network. The RCU is programmed automatically over the RF link.

Manual Setup: Quickset allows for manual selection of a Brand for programming of devices without

having to go through Auto Detection and Programming. The RCU is programmed automatically over the

RF link.

Optimized Setup Maps: OSM assists the user with a UI flow to program a TV or Audio device in the

RCU. After the user selects brand through the UI, the RCU software and Quickset allows for the testing of

functions and by the user. The RCU is programmed over the RF link after the appropriate feedback is

observed by the user.

Summary of content (4 pages)

PAGE 1
Comcast Platco TV Remote 2020 Comcast Quick Start Guide ACTIVATING RF QuickSet This product shall support the following features:  Auto Setup  Manual Setup  Optimized Setup Maps (OSM) The following are descriptions of the Quickset features: Auto Setup: Quickset allows for auto setup of the RCU by identifying devices connected through the HDMI network. The RCU is programmed automatically over the RF link.
PAGE 2
Pairing o o Press and hold DIGIT 1 + DIGIT 3 for 1 second Continuous GREEN led blink until paired or timed out LED Feedback     Pairing o GREEN led blink every 250ms for duration of advertising (10 seconds) Key Press o RED if not BLE bonded o GREEN if BLE bonded Factory Reset o 4 RED blinks before reboot Unbind BLE o 4 blinks if successful o 2 blinks if unsuccessful Features: ‐ ‐ ‐ ‐ ‐ ‐ ‐ ‐ ‐ ‐ ‐ ‐ ‐ ‐ ‐ ‐ ‐ ‐ UE878NMEH (512K Flash/64K RAM) BLE Voice with single digital MEMs microphone QS Cloud
PAGE 3
Customer Marking Label COMPLIANCE WITH FCC RULES AND REGULATIONS This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and if not used in accordance with the instructions, may cause harmful interference to radio communications.
PAGE 4
equipment without the approval of manufacturer could void the user's authority to operate this equipment. FCC Authorization Label This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference. 2 This device must accept any interference received, including interference that may cause undesired operation.