- Universal printer MAINTENANCE OWNER'S MANUAL

QUICK START

13 - Replace the Knurled Cover Retaining Knob “K” and

lightly tighten. Do not over tighten this knob or you may

bend the top of the Knurled Drive Wheel Cover “J” and

cause it to bind against the Knurled Drive Wheel. Now

retighten the Pivot Arm Knurled Knob.

11 -Replace the Knurled Drive Wheel “G” by aligning the 3

small holes with the 3 stainless drive pins on the top of the

Transfer Roll “N” and pressing the Drive Wheel onto the

Transfer Roll.

12 - Replace the Knurled Drive Wheel Cover “J” and rotate

it into position with the flat edge directly facing the Print

Drum.

FIGURE 23

FIGURE 24

FIGURE 25

The tops of the stainless pins will be flush with the top of the

Drive Wheel when seated properly.

Hold the Drive Wheel Cover and Inking System Cover in

place.

The Cover Retaining Knob should be just tight enough to keep

the Inking System Assembly together and prevent the Drive

Wheel Cover from rotating out of position.