- Universal printer MAINTENANCE OWNER'S MANUAL

QUICK START

FOR MOUNTING INSTRUCTIONS

REFER TO THE APPROPRIATE SECTION

FOR YOUR APPLICATION

WEB PRINTING - PAGE 19

CARTON PRINTING - PAGE 23

ADJUSTING THE INK ROLL ECCENTRIC

As soon as you can see complete ink coverage on the die faces,

stop rotating the eccentric. Proper adjustment will normally be

reached when the reference line on the Eccentric is somewhere

between the 2 and 3 dial position.

Note: This adjustment procedure brings the Ink Roller into contact with the surface of the Transfer Roller which

in turn applies the ink to the face of the printing dies. Do not rotate the Ink Roll Eccentric Knob further than

necessary towards the “MAX” position or the excess contact pressure will squeeze ink out of the ink roll and may

cause dripping inside the cover.

1 - After the printing dies are installed on the print drum, manu-

ally rotate the print drum continuously in one direction while

slowly rotating the Ink Roll Eccentric Adjusting Knob “I” from

the “MIN” position towards the “MAX” position. Turn the

Eccentric Knob in small increments and observe the face

of the Printing Dies “P” for signs of ink between each ad-

justment.

FIGURE 28