- Universal printer MAINTENANCE OWNER'S MANUAL

37
MAINTENANCE
INKING SYSTEM ASSEMBLY
The following steps will guide you through the Ink Roll Eccentric Assembly.
1 - Install the O-Ring in the groove of the Eccentric flange,
then install one of the white delrin washers on the Eccen-
tric.
FIGURE 74
FIGURE 75
FIGURE 76
FIGURE 77
2 - Apply a thin coating of grease to the O-Ring and the Ec-
centric to approximately 1/2” from the flange.
3 - Insert the Eccentric into the Inking System Cover. Rotate
and pull the Eccentric from the opposite side until the o-
ring slips into the bore. When fully seated, the flange of
the eccentric will be approximately 0.010” above the sur-
face of the cover. Rotate the Eccentric and align the dimple
on the Eccentric flange with the dimple in the cover.
4 - Install the second white delrin washer over the Eccentric.
Automotive wheel bearing grease is recommended.
ECCENTRIC O-RING
ALIGN DIMPLES