Specifications

Installation 2-5
1
2
2
3
4
4
5
6
7
9
9
3
3
3
5
6
7
8
9
9
9
9
1. Attach the back panel (1) to the legs (2) with the 4 screws and lockwashers (3) using the allen wrench
provided.
2. By hand, thread the 4 nuts (4) all the way down onto the caster shafts until they bottom out.
3. Carefully turn the stand upside down.
4. Install the non-locking caster (5) in the rear and the locking casters (6) in the front.
5. Tighten down the casters securely to the legs using the 3/4 inch wrench provided.
6. Carefully turn the stand right side up.
7. Lock the front casters by stepping down on the
locking tab so the stand will not roll.
8. Note the lifting points as shown, (1) and (2), on
both sides of the system. With the assistance of
one or two other people, carefully lift the laser
system and place it onto the cart assembly being
careful not to drop it or pinch your fingers.
9. Thread the remaining two screws and
lockwashers (C) through the tabs on the back
panel (A) and into the backside of the laser
system. Do not tighten down completely yet.
10. Thread the 4 screws and flat washers (H) through
the underside of the legs and into the bottom of
the laser system. Do not tighten down
completely yet.
11. Gently open the front door and see if it comes in contact with the bottom part of the legs.
12. Space the legs apart to provide clearance for the front door (1)(next page).
13. Securely tighten all remaining screws.
14. Relocate the laser system to its final resting position next to the computer and exhaust system.
1
2