Specifications

2-6 Installation
15. If the floor underneath the laser system is
uneven, the casters must be adjusted. Refer
to the following leveling instructions. Place a
bubble level across the top of the legs directly
above the front casters (2). Note the bubble
position in its sight glass. Do the same for the
back part of the legs and also note the
position of the bubble in the sight glass (3). If
the bubbles are in the same visual position,
adjustment is not necessary and cart
assembly is complete. If they are in different
positions, adjustment is required.
16. To adjust the casters, choose ONLY ONE (1)
caster and adjust its height until the bubbles
are visually identical when placing level over
the front and rear casters. The Intent is to
ensure that all casters lie in the same plane,
not to level the laser system with the ground.
If desired, you can level the laser system with
the ground although it is not required.
17. Open the top door and remove the rubber
band that is holding the arm in place.
18. Remove any remaining packing materials,
accessories or any other items that may be located inside the cabinet or on top of the engraving
table.
19. Gain access to the rear of the laser system to install the Laser Cartridge.
Laser Cartridge Installation
Before connecting and powering on your system, you must install the Laser Cartridge. Make sure that
your power cord IS NOT plugged in at this time.
With your fingers, press on the backside of the two hinges to release the latch and gently fold back the
rear cover.
1
2
3