Specifications

Installation 2-7
Visually locate the two Mounting Blocks (1), the Laser Latch (2), Alignment Fork (3), and Power
Connector (7). Notice that the Alignment Fork has two plates, one small (4)and one large (5). Locate the
gap between the two plates (6).
Observe the “V” groove along the upper (3) and lower (2) part of the Laser Cartridge. Also locate the
Alignment Plate (1) at the end of the Laser Cartridge.
Pick up the Laser Cartridge by the sides. Tilt the Laser Cartridge downward on a 30-degree angle.
Mount the cartridge onto the Mounting Blocks by placing the upper “V” groove of the cartridge on top of
the Mounting Blocks. Slide the cartridge to the right until the OUTER EDGE of the Alignment Plate
contacts the INSIDE EDGE of the large plate of the Alignment Fork.
Slowly rotate the Laser Cartridge making sure that the Alignment Plate is centered in the gap of the
Alignment Fork between the small and large plates. Keep rotating the laser until the Laser Latch “clicks”
and locks the cartridge into place. Make sure that you do not pinch any wires or hoses during this
process. This may require some slight force to actuate the latch.