Troubleshooting guide

6-4 Maintenance

#2 Mirror

To gain access to the #2 Mirror, the mirror cover must

be removed. Loosen the thumbscrew (it remains

attached to the cover) and lift the cover straight up.

Inspect the #2 Mirror and

clean it only if there is debris

present. To clean the #2

Mirror with a cotton swab,

moisten the cotton swab with

the Lens Cleaning solution

supplied with the laser

system. DO NOT use other

types of cleaners or solutions.

Gently roll the cotton swab

across the mirror once. DO NOT drag the swab or roll

it back and forth as this can scratch the mirror. If the

mirror did not come clean, use a fresh cotton swab and

repeat the procedure. Do not worry about small pieces of lint that come off of the cotton swab.

They will be vaporized as soon as the laser hits it. You can cause more damage to the mirror

by trying to get it off than by leaving it alone.

#3 Mirror and Focus Lens

You must remove the front cover

to the Focus Carriage (1) to gain

access to the #3 Mirror (3) and the

Focus Lens (4). To do this, hold

the front cover (2) with one hand

and with the other hand, remove

the three thumbscrews that attach

the front cover to the Focus

Carriage, and pull the front cover

straight out. You will notice that

the #3 Mirror and the Focus lens

are both mounted to the front

cover.

The #3 Mirror and the Focus lens

are both glued to a metal bracket

and the metal bracket is attached

to the front plate with Phillips head screws. It is not necessary to detach the bracket from either

optic in order to clean them.

1) Focus Carriage

2) Front Cover

3) #3 Mirror

)

Focus Lens