Troubleshooting guide

7-10 Sample Materials
CORIAN / AVONITE / FOUNTAINHEAD
RASTER ENGRAVING
LASER WATTAGE POWER SPEED PPI PASS DEPTH
15 100 20 500 1 .005”
20 100 27 500 1 .005”
25 100 33 500 1 .005”
30 100 40 500 1 .005”
DEEP RASTER ENGRAVING
LASER WATTAGE POWER SPEED PPI PASS DEPTH
15 100 10 1000 1 .015”
20 100 13 1000 1 .015”
25 100 17 1000 1 .015”
30 100 20 1000 1 .015”
VECTOR ENGRAVING
LASER WATTAGE POWER SPEED PPI PASS DEPTH
15 100 4.0 1000 1 .010”
20 75 4.0 1000 1 .010”
25 60 4.0 1000 1 .010”
30 50 4.0 1000 1 .010”
COMMENTS
If paint filling, mask the material first, then engrave through the masking. In this way, when
ready to paint fill, the material is already masked. Spray painting seems to be the easiest. Use
the paint sparingly. Excess paint can accumulate on the edges of the engraving, which will
make mask removal difficult and leave unsightly ridges. It is best to apply several lighter coats
than one heavy coat of paint. Remove the masking after the paint has dried.
WARNING: ENGRAVING THIS MATERIAL PRODUCES ABRASIVE
PARTICLES. Clean the laser system more frequently to reduce wear and
tear on the motion system components and optics. Damage to the laser
system from inadequate or insufficient maintenance WILL NOT be
covered under warranty.