Troubleshooting guide

Sample Materials 7-11
CORK
RASTER ENGRAVING
LASER WATTAGE POWER SPEED PPI PASS DEPTH
15 80 30 500 1 .010”
20 80 40 500 1 .010”
25 80 50 500 1 .010”
30 80 60 500 1 .010”
VECTOR ENGRAVING
LASER WATTAGE POWER SPEED PPI PASS DEPTH
15 20 4.0 500 1 .010”
20 15 4.0 500 1 .010”
25 12 4.0 500 1 .010”
30 10 4.0 500 1 .010”
VECTOR CUTTING
LASER WATTAGE POWER SPEED PPI PASS DEPTH
15 100 1.6 100 1 .060”
20 75 1.6 100 1 .060”
25 60 1.6 100 1 .060”
30 50 1.6 100 1 .060”
COMMENTS
Cork is not very popular for engraving but it does engrave and cut nicely. Cork is mainly used
for making gaskets by vector cutting the gasket patterns.
WARNING: LASER CUTTING THIS MATERIAL CAN CAUSE FLAMING
AND SPARKING. Use caution when attempting to cut this material. It
would be better to use a longer focal length lens to prevent the lens from
being damaged during processing. NEVER leave the machine unattended
while processing any material. Damages caused by processing any
material WILL NOT be covered under warranty.