Specifications

Section 5
Accessories
As an addition to the regular VersaLASER, we offer a wide variety of optional accessories. Before
attempting to use any of the accessories in this section, make sure that you are comfortable
operating the VersaLASER, the VCP, and your graphics software.
Rotary Fixture
This accessory allows the VersaLASER to be quickly reconfigured to
raster engrave, vector mark, or vector cut (material dependent),
cylindrical objects such as glassware, etc.
NOTE: If this is your first time using the Rotary Fixture, we highly recommend that you practice
this procedure several times on some inexpensive scrap material before attempting to engrave
the actual object.
Installation
Lower the table all the way down to the bottom of its travel or down far enough so that you can remove
the table and install the Rotary Fixture without interfering with the moving parts of the VersaLASER.
Remove the table by loosening the two captive
thumbscrews (1). Insert your fingers into the two
holes (2) and slowly lift the table out of the
VersaLASER being careful not to bump it around.
Inside the VersaLASER you will find the large
recessed slot with a self-aligning electrical
connector to the right side (1) and the two
alignment pins (2).