Specifications

ACCESSORIES
Section 5-2
On the underside of the Rotary Fixture notice the
self-aligning electrical connector (1) and two
alignment holes (2).
Insert the Rotary Fixture into the slot (OK to do
with the power on because it is hot swappable)
and move it around until the connector engages,
the pins protrude through the alignment holes,
and the fixture sits flat. It will indicate that it is
installed properly by automatically rotating its
cone slightly and a Rotary button will appear in
the Focus tab of the VCP.
Basic Operation
In this example, we are going to engrave a simple drinking glass.
Before loading the glass into the fixture, using a
dry erase marker or some other marking device,
make a mark on the glass where you would like
the place the TOP CENTER point of the graphic.
Using a caliper or similar measuring device,
measure the diameter across the area of the glass
where you marked. Either remember this number
or write it down.