Specifications

ACCESSORIES
Section 5-7
Figure 1 (Front View)
1. Four “foot” ports to secure the
VersaLASER to the cart and prevent
slipping (1)
2. Pre-filter and HEPA filter drawer
3. Charcoal filter drawer
4. Locking casters
Figure 2 (Rear View)
1. Exhaust intake port
2. Cable retainer clips
3. USB port
4. Exhaust output port
5. Power inlet, electrical power requirement
label, Warning label, fuse holder
How it works
This device contains a pre-filter to remove coarse (larger) particulates, a HEPA filter to remove fine
(smaller) particulates, an activated charcoal filter to remove fumes and odors, and a high-pressure
vacuum motor to pull these byproducts through the filters. It also serves as a moveable base, or stand,
for the VersaLASER. To reduce noise, minimize electrical consumption, and prolong filter life, the CCAC
is controlled from the VersaLASER via a USB cable. The VersaLASER powers on the CCAC when
processing begins and powers it off a few seconds after the processing completes to remove any
remaining particulates, fumes, or smoke.
NOTE: When the filters are reaching their useful life, the VCP software will prompt you and inform
you how much of a percent of its useful life has expired, starting at 85%. That would be a good
time to reorder filters.