Specifications

ACCESSORIES
Section 5-8
Installation
• Push down on the tabs of the locking casters so that the cart does not roll.
• Obtain the assistance of another person. One person should grasp the front of the machine and
place his hands where the arrows indicate. The other person should stand in the back of the machine
and place his hands where the arrows indicate.
• Pick up the VersaLASER, place it on top of the cart and locate the VersaLASER’s four feet into the
four, foot ports.
Making the Connections
NOTE: Before continuing, you MUST have completed Section 2 of this manual which includes
loading the VersaLASER Installation Software. If not, go back to that section, complete the
installation, and return here.
• Connect the short exhaust hose and secure it with the provided hose clamps (1) and install the sheet
metal cover over the exhaust hose.
• Make sure you computer is powered on and booted into Windows.
• As instructed in Section 2 plug in a power cord to the VersaLASER’s power inlet (6) and attach a USB
cable from your computer to the VersaLASER USB port 1.
• Plug in a power cord to the CCAC’s power inlet (5) and then connect a 3 ft. USB cable between the
second USB port (2) of the VersaLASER and the USB port located towards the bottom of the CCAC
(3). NOTE: Windows will indicate to you that it has recognized the device by powering it on for
about 5 seconds and then automatically turning it off. Once this occurs, it is ready for use. If
Windows does not recognize the device it will prompt you for the device driver disk again.
Insert your VersaLASER Installation CD-ROM and follow the on-screen instructions.
• Secure the USB cable using the retainer clips (4).