Specifications

ACCESSORIES
Section 5-10
Periodic Maintenance
At least once per month, check the condition of
the two filters on the back of the device. If they
are plugged, simply remove them by snapping off
the cover, removing the filter media, washing it out
with ordinary soap and water, dry the filters, and
re-install. If the filters remained relatively clean,
adjust your maintenance schedule accordingly.
Below the device you will find a tray. With your
hands, slide the tray forwards. Inside the tray you
will find sponges that are designed to absorb the
water that was generated from condensation. In
humid areas you may need to check the sponges
more than once per week. In drier areas it is
possible to extend that period. Check them at
least once per week and adjust your schedule
accordingly. The sponges may need to be
cleaned with soap and water and dried out, or
replaced.
Air Assist Cone
This accessory also requires the Computer Controlled Compressed Air Unit.
NEVER install the Air Assist Cone without having the Computer
Controlled Air Compressor Unit installed and operating, and
NEVER shut off the needle valve completely. The lack of
pressurized air present in the cone, during processing, will allow
smoke to contaminate the lens and can destroy it within seconds.
The cone attaches to the base of the Focus Carriage and will force air directly onto the surface of your
material to reduce the burning effects of the material from the laser beams intense heat. It also helps
disperse the smoke and gases that are created from the cutting or engraving of materials. It contains a
needle-valve assembly to control airflow through the cone.
WARNING