Specifications

PRINTER DRIVER CONTROLS
Section 2-6
CorelDRAW12
1. Using Windows Explorer, locate the file named “VersaLASER.CPL”, on the VersaLASER
Installation CD, and copy this file over to the C C:\Program Files\Corel\Corel Graphics
12\Languages\EN\Custom Data\Palettes folder.
2. While still in Explorer, locate a file named “corelapp.ini” located in the C:\Program
Files\Corel\Graphics12\Config folder. Double-click on the file it will open up in Notepad. Scroll
down past the semi-colons to the [Config] header. Then scroll down 31 lines to the line that reads
“Fontrasterizer=1”. Change the 1 to a 0 (this is a zero, not an o), save the file, and exit Notepad.
3. Open CorelDRAW12 and start a new graphic.
4. In the menu bar, click on “Window”, then “Color Palettes”, and then click “None”. Once again click
“Window”, then “Color Palettes”, and then “Open Palette”. In the pop-up box, double-click on
"VersaLASER.CPL" which allows it to appear on the right side of the screen.
5. On the property bar, click on the landscape orientation (the sideways rectangle). Enter the page
width of 16 inches (406.4mm) (model VL-200) or 24 inches (609.6mm) (model VL-300) and
height of 12 inches (304.8mm).
6. The rulers on screen need to match the rulers in the VersaLASER. Adjust the ruler's vertical
origin by double-clicking directly on the vertical (side) ruler. The “Options” dialog box will appear.
In the vertical origin box, type in 12 inches (304.8mm). Click OK
7. Set the default value for line width and color of the graphic objects, by clicking the outline tool and
then the outline pen dialog in the flyout. With “Graphic” being the only selection checked, click
“OK”. Click the down arrow in the Color dropdown box to expand the list and click on the color
red. Click the down arrow in the “Width” dropdown box and click “Hairline”. The units can be
“inches”, “millimeters” or anything else you prefer. Click “OK to close the Outline Pen dialog box.
8. In the top menu, click “Tools, then click “Color Management”. Click on the down arrow to expand
the “Style” dropdown list. Click “Color Management Off”, and then click “OK”.
9. Finally, at the top of the screen, click on “Tools”, then “Options”, then “Document”, and then select
“Save Options as Defaults for New Documents”. Make sure ALL the options listed are
CHECKED then click “OK”.
10. The setup defaults for CorelDRAW12 are now complete. Whenever you start a new document,
all of the default settings that we had setup will automatically apply to the new document.
Remove the VersaLASER Installation CD-ROM from your CD-ROM drive and store it either back
into the pocket of the rear cover of the manual or in a safe place.