Specifications

Printer Driver Controls
Section 3-10
CORIAN / AVONITE / FOUNTAINHEAD
RASTER ENGRAVING
LASER WATTAGE POWER SPEED PPI PASS DEPTH
10 100 20 500 1 .005”
25 100 33 500 1 .005”
30 100 40 500 1 .005”
35 100 47 500 1 .005”
40 100 53 500 1 .005”
45 100 60 500 1 .005”
50 100 67 500 1 .005”
DEEP RASTER ENGRAVING
LASER WATTAGE POWER SPEED PPI PASS DEPTH
10 100 10 1000 1 .015”
25 100 17 1000 1 .015”
30 100 20 1000 1 .015”
35 100 23 1000 1 .015”
40 100 27 1000 1 .015”
45 100 30 1000 1 .015”
50 100 33 1000 1 .015”
VECTOR ENGRAVING
LASER WATTAGE POWER SPEED PPI PASS DEPTH
10 100 4.0 1000 1 .010”
25 60 4.0 1000 1 .010”
30 50 4.0 1000 1 .010”
35 43 4.0 1000 1 .010”
40 38 4.0 1000 1 .010”
45 33 4.0 1000 1 .010”
50 30 4.0 1000 1 .010”
COMMENTS
If paint filling, mask the material first, then engrave through the masking. In this way, when ready to paint
fill, the material is already masked. Spray painting seems to be the easiest. Use the paint sparingly.
Excess paint can accumulate on the edges of the engraving, which will make mask removal difficult and
leave unsightly ridges. It is best to apply several lighter coats than one heavy coat of paint. Remove the
masking after the paint has dried.
ENGRAVING THIS MATERIAL PRODUCES ABRASIVE PARTICLES. Clean the laser
system more frequently to reduce wear and tear on the motion system components and
optics. Damage to the laser system from inadequate or insufficient maintenance WILL
NOT be covered under warranty.