Specifications

Printer Driver Controls
Section 3-11
CORK
RASTER ENGRAVING
LASER WATTAGE POWER SPEED PPI PASS DEPTH
10 80 30 500 1 .010”
25 80 50 500 1 .010”
30 80 60 500 1 .010”
35 80 70 500 1 .010”
40 80 80 500 1 .010”
45 80 90 500 1 .010”
50 80 100 500 1 .010”
VECTOR ENGRAVING
LASER WATTAGE POWER SPEED PPI PASS DEPTH
10 20 4.0 500 1 .010”
25 12 4.0 500 1 .010”
30 10 4.0 500 1 .010”
35 9 4.0 500 1 .010”
40 8 4.0 500 1 .010”
45 7 4.0 500 1 .010”
50 6 4.0 500 1 .010”
VECTOR CUTTING
LASER WATTAGE POWER SPEED PPI PASS DEPTH
10 100 1.6 100 1 .060”
25 60 1.6 100 1 .060”
30 50 1.6 100 1 .060”
35 43 1.6 100 1 .060”
40 38 1.6 100 1 .060”
45 33 1.6 100 1 .060”
50 30 1.6 100 1 .060”
COMMENTS
Cork is not very popular for engraving but it does engrave and cut nicely. Cork is mainly used for making
gaskets by vector cutting the gasket patterns.
LASER CUTTING THIS MATERIAL CAN CAUSE FLAMING AND SPARKING. Use
caution when attempting to cut this material. It would be better to use a longer focal
length lens to prevent the lens from being damaged during processing. NEVER leave
the machine unattended while processing any material. Damages caused by
processing any material WILL NOT be covered under warranty.